Lincoln Nautilus: Rear Seats / Rear Seat Cushion. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Release the rear seat cushion front locking tabs.
-
Release the rear seat cushion.
-
Raise the front of the cushion.
-
Push the cushion rearward until the cushion frame clears the attaching hooks.
-
NOTE:
Outboard recliner handle and side shield removed for clarity.
Disconnect the electrical connector and remove the rear seat cushion.
Installation
-
To instal, reverse the removal procedure.
Removal
NOTE:
LH rear seat shown, RH rear seat similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rear seat backrest...
Removal
Remove the rear seat cushion.
Refer to: Rear Seat Cushion (501-10B Rear Seats, Removal and Installation).
Release the rear seat cushion cover J-clips...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Drivers seat SCMG shown, passenger seat SCMH similar.
NOTE:
This step is only necessary when installing a new component.
NOTE:
The PMI process must begin with the current SCMG or SCMH installed...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
If installing a new steering gear, upload the PSCM configuration to the scan tool.
Refer to: Module Configuration - System Operation and Component
Description (418-01A Module Configuration, Description and Operation)...