Lincoln Nautilus: Rear Seats / Rear Seats - Overview. Description and Operation
Overview
Heated Seats
If equipped, the rear heated seat system allows the rear seat cushion and backrest to be heated at one of two levels on demand.
The components of the rear heated seat system include:
-
Seat cushion heater mat
-
Seat backrest heater mat
-
Heated seat module (attached to the underside of the rear seat cushion)
-
Heated seat switches (located in the rear panel of the front floor console)
Power-Fold Down Backrest
If equipped, when the LH or RH power fold seat control switch (mounted in the LH
rear quarter trim panel rear hatch area) is pushed, an
electromechanical motor releases that seat's recliners through a cable
attachment. When the recliner is released, a spring load folds the
backrest down and kneels the front legs. The seat backrest must then be
manually lifted upright to the seating position locking the recliners
into place.
System Operation
Rear Heated Seats
The
heated seats operate in a sequence of high, low and off with each press
of the heated seat switch. Rear heated seats are equipped with a single
heated seat module to control both outboard rear heated seats...
Other information:
System Operation
System Diagram - Memory Seat
Item
Description
1
Memory Power Seat Motors
2
HS1-CAN
3
PCM
4
HS1-CAN
5
Ignition Switch
6
GWM
7
Memory SET Switch
8
MS-CAN
9
DSM
10
MS-CAN
11
DDM
12
Position Sensors
13
Motors
14
LIN
15
With Multi-Contour Seats
16
Driver Seat Control Swi..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary if the HCM is being replaced.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation.
NOTE:
If ..