Lincoln Nautilus: Steering Column / Steering Wheel Cover Repair. General Procedures
Materials
| Name | Specification |
|---|---|
| Motorcraft® Instant Gel Adhesive TA-19-C |
WSS-M2G401-B5 |
Repair
Steering wheel with adaptive steering
NOTE: Steering wheel with SECM is not meant to be repaired, the steering wheel must be replaced.
-
Remove the steering wheel.
Refer to: Steering Wheel - Vehicles With: Adaptive Steering (211-04 Steering Column, Removal and Installation).
Steering wheel without adaptive steering
-
NOTE: If re-adhering leather to the front side of the steering wheel only, it will not be necessary to remove the steering wheel. Steering wheel removal is necessary only when repairing loose leather on the backside of the steering wheel.
If necessary, remove the steering wheel.
Refer to: Steering Wheel (211-04 Steering Column, Removal and Installation).
-
Position the loose leather out of the way.
-
Apply the specified adhesive evenly over the wheel spoke.
Material: Motorcraft® Instant Gel Adhesive / TA-19-C (WSS-M2G401-B5)
-
Position the loose leather back into the original position.
-
NOTE: The adhesive should be completely set after 5 minutes. Do not pull on the repair area.
Smooth the leather and tuck in for neat appearance.
-
Apply pressure (for at least 30 seconds) until the leather is bonded to the wheel spoke.
-
If removed, install the steering wheel.
Refer to: Steering Wheel (211-04 Steering Column, Removal and Installation).
Steering Column. Diagnosis and Testing
DTC Chart: SCCM
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Steering Column. Removal and Installation
Removal
NOTICE:
To prevent damage to the clockspring, make sure the front wheels are in the straight-ahead position.
NOTICE:
Precise tolerances are required when manufacturing a
steering column...
Other information:
Lincoln Nautilus 2018-2026 Owners Manual: Front Seats
Front Seat Precautions WARNING: Sitting improperly, out of position or with the seatback reclined too far can take weight off the seat cushion and affect the decision of the passenger sensing system, resulting in serious injury or death in the event of a crash...
Lincoln Nautilus 2018-2026 Service Manual: Passenger Side Register Air Discharge Temperature Sensor. Removal and Installation
Removal Remove the instrument panel. Refer to: Instrument Panel (501-12 Instrument Panel and Console, Removal and Installation). Disconnect the electrical connector. Rotate and remove the sensor. Installation To install, reverse the removal procedure...
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Auto-Start-Stop
- Interior Lamp Function. Adjusting the Instrument Panel Lighting Brightness. Ambient Lighting. Interior Lighting – Troubleshooting
- Anti-Theft Alarm System Settings. Security – Troubleshooting
- New on site
- Most important about car
Changing a Flat Tire
WARNING: If the tire pressure monitor sensor becomes damaged it may not function.
Note: The use of tire sealant may damage your tire pressure monitoring system and should only be used in roadside emergencies. If you must use a sealant, use the Tire Mobility Kit sealant. Replace the tire pressure monitoring system sensor and valve stem on the wheel by an authorized dealer after use of the sealant.
Note: The tire pressure monitoring system indicator light will illuminate when the spare tire is in use. To restore the full function of the monitoring system, all road wheels equipped with tire pressure monitoring sensors must be mounted on the vehicle.
If you get a flat tire while driving, do not apply the brake hea
