Other information:
Check
NOTE:
The object used in this system check can be
fabricated using a 9 cm diameter (3 in I.D.) pipe, 100 cm (39 in) in
length (available as Polyvinyl Chloride (PVC) pipe, or similar from a
hardware or plumbing supply.
NOTE:
The following system check should be carried out with the vehicle on a level surface...
Removal
NOTE:
This step is only necessary if the IPMB is being replaced.
NOTE:
This procedure can be used for all locations of the component.
Using a diagnostic scan tool, begin the PMI process for the IPMB following the on-screen instructions...