Lincoln Nautilus: Climate Control System - General Information / Ambient Air Temperature Sensor. Removal and Installation
Removal
-
Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
-
Detach and remove the ambient air temperature sensor. Disconnect the electrical connector.
Installation
-
To install, reverse the removal procedure.
-
If replacing the ambient air temperature sensor a reset must be performed.
Refer to: Reset the Outside Air Temperature Sensor Learned Values
(412-00 Climate Control System - General Information, General
Procedures).
Removal
Remove the instrument panel.
Refer to: Instrument Panel (501-12)
.
Disconnect the electrical connector, remove the retainers and the air inlet door actuator...
Removal
Remove the passenger knee air bag.
Refer to: Passenger Knee Airbag (501-20B Supplemental Restraint System, Removal and Installation).
Disconnect the electrical connector, detach the wiring
harness retainer and position aside the harness...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Release the rear seat cushion front locking tabs.
Release the rear seat cushion.
Raise the front of the cushion.
Push the cushion rearward until the cushion frame clears the attaching hooks...
Item
2.0L EcoBoost
2.7L EcoBoost
Driveshaft runout
0.6 mm (0.024 in)
0.6 mm (0.024 in)
Driveshaft to PTU joint angle @ curb ride height
3.41°
4.86°
Driveshaft center bearing "1" joint angle @ curb ride height (Center bearing closest to the PTU)
4...