Lincoln Nautilus: Perimeter Anti-Theft Alarm / Anti-Theft Alarm Horn. Removal and Installation
Removal
-
Remove the RH loadspace trim panel.
Refer to: Loadspace Trim Panel (501-05)
.
-
If equipped, remove the subwoofer and amplifier unit.
Refer to: Subwoofer and Amplifier Unit (415-00 Information and
Entertainment System - General Information - Vehicles With: SYNC 4,
Removal and Installation).
Refer to: Subwoofer and Amplifier Unit (415-00 Information and
Entertainment System - General Information - Vehicles With: SYNC 4,
Removal and Installation).
-
Remove the anti-theft alarm horn.
-
Remove the bolt.
-
Disconnect the electrical connector.
-
Release the hooks and remove the anti-theft alarm horn.
Installation
-
To install, reverse the removal procedure.
DTC Charts
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Removal
Remove the overhead console.
Refer to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation).
Release the tabs and position aside the sensors...
Other information:
Rollover Warning
WARNING: Utility vehicles have a
significantly higher rollover rate than other
types of vehicles.
WARNING: Vehicles with a higher
center of gravity (utility and four-wheel
drive vehicles) handle differently than
vehicles with a lower center of gravity
(passenger cars)...
Trailer Towing Connector (If Equipped)
When attaching the trailer wiring connector
to your vehicle, only use a proper fitting
connector that works with the vehicle and
trailer functions.
Note: Install the waterproof protection cap
back onto the trailer towing connector
whenever it is not in use...