Lincoln Nautilus: Front Disc Brake / Brake Disc Shield. Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
-
Remove the brake disc.
Refer to: Brake Disc (206-03 Front Disc Brake, Removal and Installation).
-
Remove the bolts and the brake disc shield.
Torque: 159 lb.in (18 Nm)
 |
Installation
-
To install, reverse the removal procedure.
Brake Disc. Removal and Installation
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C
-
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Brake Pads. Removal and Installation
Special Tool(s) /
General Equipment
Brake Caliper Piston Retractor
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C
-
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Lincoln Nautilus 2018-2026 Service Manual: Heater Core. Removal and Installation
Removal NOTE: If a heater core leak is suspected, the heater core must be leak tested before it is removed from the vehicle. Remove the climate control housing. Refer to: Climate Control Housing (412-00) . Remove the heater tube dash panel seal...
Lincoln Nautilus 2018-2026 Service Manual: Power Fold Seat Control Switch. Removal and Installation
Special Tool(s) / General Equipment Interior Trim Remover Removal On both sides. Using an interior trim tool, release the power fold seat control switch locking tabs. Use the General Equipment: Interior Trim Remover Disconnect the electrical connector and remove the power fold seat control switch...
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Folding the Exterior Mirrors - Vehicles With: Manual Folding Mirrors. Folding the Exterior Mirrors - Vehicles With: Power Folding Mirrors
- Normal Scheduled Maintenance
- Fuel Quality
- New on site
- Most important about car
Changing a Flat Tire
WARNING: If the tire pressure monitor sensor becomes damaged it may not function.
Note: The use of tire sealant may damage your tire pressure monitoring system and should only be used in roadside emergencies. If you must use a sealant, use the Tire Mobility Kit sealant. Replace the tire pressure monitoring system sensor and valve stem on the wheel by an authorized dealer after use of the sealant.
Note: The tire pressure monitoring system indicator light will illuminate when the spare tire is in use. To restore the full function of the monitoring system, all road wheels equipped with tire pressure monitoring sensors must be mounted on the vehicle.
If you get a flat tire while driving, do not apply the brake hea
