Lincoln Nautilus: Information and Entertainment System - General Information - Vehicles With: SYNC 4 / Center Display Screen. Removal and Installation
Special Tool(s) /
General Equipment
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Release the clips and remove the information and entertainment display unit trim panel.
Use the General Equipment: Interior Trim Remover
-
Remove the bolts and position the information and entertainment display unit.
Torque:
13 lb.in (1.5 Nm)
-
Disconnect the electrical connectors and remove the information and entertainment display unit.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
RH side is shown, the LH side is similar.
Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19)
.
Remove the rivets, the pin type retainer and the cellular phone antenna...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the D-pillar trim panel.
Refer to: D-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Other information:
WARNING: Do not place objects or
mount equipment on or near the airbag
cover, on the side of the front or rear
seatbacks, or in areas that may come into
contact with a deploying airbag. Failure to
follow these instructions may increase the
risk of personal injury in the event of a
crash...
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Module
DTC
Description
Action
PAM
B1303:13
Park Assist Switch: Circuit Open
GO to Pinpoint Test D
PAM
B1303:9E
Park Assist Switch: Stuck On
GO..