Lincoln Nautilus: Information and Entertainment System - General Information - Vehicles With: SYNC 4 / Cellular Phone Antenna. Removal and Installation

Lincoln Nautilus 2018-2026 Service Manual / Electrical / Information and Entertainment Systems / Information and Entertainment System - General Information - Vehicles With: SYNC 4 / Cellular Phone Antenna. Removal and Installation

Removal

NOTE: RH side is shown, the LH side is similar.

Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19) .

Remove the rivets, the pin type retainer and the cellular phone antenna.

Installation

To install, reverse the removal procedure.

Cellular Antenna Cable Splitter. Removal and Installation

Special Tool(s) / General Equipment Interior Trim Remover Removal If equipped. Remove the load compartment cover. Remove the load compartment floor cover...

Center Display Screen. Removal and Installation

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details...

Other information:

Lincoln Nautilus 2018-2026 Service Manual: Headliner - Lowering. Removal and Installation

Special Tool(s) / General Equipment Interior Trim Remover Remove the following items: On both sides. Remove the A-pillar trim panels. Refer to: A-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...

Lincoln Nautilus 2018-2026 Service Manual: Exterior Lighting - System Operation and Component Description. Description and Operation

System Operation Headlamps System Diagram Item Description 1 HS-CAN2 2 BCM 3 LH low beam 4 LH high beam 5 RH low beam 6 RH high beam 7 SCCM 8 LH steering column multifunction switch 9 IPMA 10 GWM 11 HS-CAN1 12 Start/Stop switch 13 HCM 14 LIN ..

Clearing the Garage Door Opener. Reprogramming the Garage Door Opener. Garage Door Opener Radio Frequencies

Clearing the Garage Door Opener

Lincoln Nautilus. Clearing the Garage Door Opener. Reprogramming the Garage Door Opener. Garage Door Opener Radio Frequencies

Press and hold the outer two function buttons simultaneously for approximately 10 seconds until the indicator light above the buttons flashes rapidly. When the indicator light flashes, release the buttons.