Lincoln Nautilus: Climate Control System - General Information / Electronic Leak Detection. General Procedures

Inspection

1. NOTE: Depending on refrigerant used:

   • Use a Rotunda-approved Electronic Leak Detector for R134a refrigerant SAE Certified to J2791.
   • Use a Rotunda-approved Electronic Leak Detector for R-1234yf refrigerant SAE Certified to J2913.

   NOTE: Good ventilation is necessary in the area where electronic A/C leak testing is to be carried out. If the surrounding air is contaminated with refrigerant gas, the leak detector indicates this gas all the time. Odors from other chemicals such as antifreeze, disc brake cleaner or other cleaning solvents can cause the same problem. Using a fan to ventilate the area to be tested before proceeding with the leak detection procedure is helpful in removing small traces of contamination from the air, but the fan should be turned off during actual testing.

   NOTE: If the surrounding air is contaminated with refrigerant gas, the leak detector indicates this gas all the time. Odors from other chemicals such as antifreeze, disc brake cleaner or other cleaning solvents can cause the same problem.

   NOTE: R134a or R-1234yf, if present, is heavier than air, and tends to move down from the source of the leak. It is possible that a leak may not be detected if the leak detector tip is held above the leaking fitting, line or component. Always be sure to thoroughly leak test below, above and around the fitting, line or component for the presence of R134a or R-1234yf.

   Leak check the service ports. Remove caps and blow air over the service ports to remove trapped refrigerant before leak testing ports.
   
   • For access to the correct Ford approved Refrigerant Leak Detector.
     Refer to: Climate Control Tools and Equipment (412-00 Climate Control System - General Information, General Procedures).
     

1. NOTE: The system pressure should be 413-551 kPa (60 - 80 psi) at 24° C (75.2° F) with the engine off and cool. The pressure reading may be higher if the engine is hot.

   Leak test the refrigerant system. Follow the instructions included with the Electronic Leak Detector for handling and operation techniques.