Lincoln Nautilus: General Information / Engine Cooling System Health and Safety Precautions. Description and Operation
WARNING:
Always allow the engine to cool before opening the cooling
system. Do not unscrew the coolant pressure relief cap when the engine
is operating or the cooling system is hot. The cooling system is under
pressure; steam and hot liquid can come out forcefully when the cap is
loosened slightly. Failure to follow these instructions may result in
serious personal injury.
This
document provides critical diagnostic knowledge required for successful
repair outcomes. It identifies technical competencies expected by users
of this manual...
WARNING:
Before working on or disconnecting any of the fuel tubes or fuel
system components, relieve the fuel system pressure to prevent
accidental spraying of fuel...
Other information:
System Diagram
Item
Description
1
DDM
2
SCCM
3
Memory Set Switch
4
DSM
5
BCM
6
MS-CAN
7
HS2-CAN
8
Steering Column Control Switch
9
Steering Column Tilt Motor
10
Hall Effect Sensor
11
GWM
12
Steering Column Telescopic Motor
13
Hall Effect Sensor
14
HS1-CAN
System Operation
Network Message..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH similar.
Open the door.
Remove the rear check arm bolt.
Torque:
18 lb.ft (25 Nm)
Remove the rear door trim panel.
Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installa..