Lincoln Nautilus: Exterior Trim and Ornamentation / Front Fender Moulding. Removal and Installation
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the pushpins and clip from the rear of the moulding.
-
Remove the pushpins at the front edge of the moulding.
-
NOTICE:
To avoid damage to the moulding, only use moderate force.
Using a non-marring trim removal tool, disengage the retainer clips from the fender.
-
Remove the moulding.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Vehicles With: Keyless Entry
Remove the front door latch on the affected side, to gain clearance for removal of the electrical connector...
Removal
NOTE:
LH side shown RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
NOTICE:
To avoid damage to the moulding, only use moderate force...
Other information:
DTC Charts
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
BCM
DTC Chart
DTC
Description
Action
B108A:01
Start Button: General Electrical Failure
GO to Pi..
Removal
Remove the rear spoiler.
Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation, Removal and Installation).
Remove the high mounted stoplamp.
Disconnect the high mounted stoplamp electrical connector.
Remove the retainers.
Separate the high mounted stoplamp from the rear spoiler.
Installation
To..