Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to upload the
module configuration information to the scan tool prior to removing the
module. This information must be downloaded into the new module after
installation.
Using a diagnostic scan tool, begin the PMI process for the TCU following the on..
Inspection
NOTE:
Do not use a caustic cleaning solution or a wire brush to clean the pistons or damage can occur.
Clean and inspect the (1) ring lands, (2) pin bosses,
(3) skirts and the (4) tops of the pistons. If wear marks, scores or
glazing is found on the piston skirt, check for a bent or twisted
connecting rod.
NOTE:
Make sure the oil ring hol..