Lincoln Nautilus: Exterior Trim and Ornamentation / Rear Quarter Panel Moulding. Removal and Installation
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
-
If equipped, remove the pushpins and remove the deflector.
-
Remove the pushpins from the rear of the moulding.
-
NOTICE:
To avoid damage to the moulding, only use moderate force.
Remove the screw and spring clip at the front corner of
the moulding, and disengage the clips from the quarter panel using a
non-marring trim removal tool.
-
Remove the moulding.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Aft Rear Door Upper Moulding
Remove the front screw from the upper belt moulding...
Removal
NOTE:
Removal steps in this procedure may include installation details.
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Other information:
Stopping the Engine When Your Vehicle is Stationary
Shift into park (P).
Apply the parking brake.
Wait until the engine reaches idle speed.
Press the push button ignition switch.
Stopping the Engine When Your Vehicle is Moving
WARNING: Switching off the engine
when your vehicle is still moving results in
a significant decrease in braking
assistance...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation).
Disconnect the electrical connectors, remove the screws and the hands-free liftgate actuation module...