Lincoln Nautilus: Handles, Locks, Latches and Entry Systems / Keyless Entry Keypad. Removal and Installation
Removal
NOTE:
The keyless entry keypad is serviced as an assembly with the front door upper moulding.
-
Remove the front door window moulding.
Refer to: Front Door Upper Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation).
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
LH side shown, RH side similar.
Remove the rear door trim panel.
Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Removal
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Remove the keyless entry rear antenna...
Other information:
Removal
NOTE:
LH side shown, RH side similar.
Remove the rear door trim panel.
Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Remove the rear door watershield.
Lower the rear window glass to full down position...
If you are unable to start the engine, do the
following:
Open the floor console storage
compartment lid.
With the buttons facing upward and the
unlock button facing the front of your
vehicle, place the passive key into the
backup slot.
With the key in this position, press the
brake pedal then press the push button
ignition switch to switch the ignition on
and start your vehicle...