Lincoln Nautilus: Multifunction Electronic Modules / Passenger Door Module (PDM). Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. NOTE: If installing a new module, it is necessary to upload the module configuration information to the diagnostic scan tool prior to removing the module. This information must be downloaded into the new module after installation.

   Carry out the PMI procedure for the PDM .
   Refer to: Module Programming (418-01 Module Configuration) .
   

1. Remove the front door trim panel.
   Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
   

1. 
   Remove the bolts and the PDM .
   
   • Disconnect the elecrical connectors.
     Torque: 44 lb.in (5 Nm)

Installation

1. To install, reverse the removal procedure.
   

1. Using the previous diagnostic scan tool session, carry out the PMI procedure for the PDM .
   

1. If installing a new module, carry out the power door window initialization.
   Refer to: Power Door Window Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).