Lincoln Nautilus: Exterior Lighting / Reversing Lamp. Removal and Installation
Removal
-
Remove the liftgate interior trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Disconnect the reversing lamp electrical connectors.
 |
-
Remove the reversing lamp assembly.
-
Remove the reverse lamp nuts.
-
Push the wiring harness through the liftgate and remove the reversing lamp assembly.
-
Remove the reverse lamp nuts.
 |
Installation
-
To install, reverse the removal procedure.
Rear Lamp Fade Control Module. Removal and Installation
Removal
Remove the LH loadspace interior trim panel.
Refer to: Loadspace Trim Panel (501-05)
.
Disconnect the rear lamp fade control module electrical connector...
Stoplamp Switch. Removal and Installation
Removal
NOTICE:
Do not press, pull or otherwise move the brake pedal while
installing the stoplamp switch and cruise control deactivation switch.
Install these switches with the booster push rod attached to the brake
pedal and with the brake pedal in the at-rest position...
Other information:
Lincoln Nautilus 2018-2026 Service Manual: Hands-Free Liftgate Actuation Lower Sensor. Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. Remove the rear bumper cover. Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation). Remove the lower rear bumper cover. Remove the rivets...
Lincoln Nautilus 2018-2026 Service Manual: Parking Aid. Diagnosis and Testing
Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action PAM B1303:13 Park Assist Switch: Circuit Open GO to Pinpoint Test D PAM B1303:9E Park Assist Switch: Stuck On GO..
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Programming the Garage Door Opener to Your Garage Door Opener Motor
- Fuel Quality
- Changing the 12V Battery
- New on site
- Most important about car
Traction Control
How Does Traction Control Work
If your vehicle begins to slide, the system applies the brakes to individual wheels and, when needed, reduces power at the same time. If the wheels spin when accelerating on slippery or loose surfaces, the system reduces power in order to increase traction.
Switching Traction Control On and Off
WARNING: The stability and traction control light illuminates steadily if the system detects a failure. Make sure you did not manually disable the traction control system using the information display controls or the switch. If the stability control and traction control light is still illuminating steadily, have the system serviced by an authorized dealer immediately. Operating your vehicle with the traction co
