Lincoln Nautilus: Steering Wheel and Column Electrical Components / Steering Column Multifunction Switch RH. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the steering column shrouds.
Refer to: Steering Column Shrouds (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
NOTE:
Make sure the component terminals are not bent or damaged.
Remove the screws and the RH steering column multifunction switch.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the steering column shrouds.
Refer to: Steering Column Shrouds (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Steering wheel with active steering shown others similar...
Other information:
Special Tool(s) /
General Equipment
8 mm Drill Bit
MIG/MAG Welding Equipment
Spot Weld Drill Bit
Locking Pliers
Materials
Name
Specification
Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM
-
Removal
NOTE:
LH side shown, RH side similar...
Bring the engine to normal operating temperature. Connect
the Vacuum/Pressure Tester to the intake manifold. Run the engine at the
specified idle speed.
The vacuum gauge should read between 51-74 kPa (15-22 in-Hg)
depending upon the engine condition and the altitude at which the test
is conducted...