Lincoln Nautilus: Keyless Entry Keypad / Using the Keyless Entry Keypad
Unlocking the Doors
Enter the factory-set five-digit code or your personal code. You must press each number within five seconds of each other.
- Press 3-4 within five seconds to unlock all doors.
Locking the Doors
Press and hold 7·8 and 9·0 at the same time with the driver door closed.
Note: You do not need to enter the code first.
Keyless Entry Keypad – Troubleshooting
Keyless Entry Keypad – Frequently Asked Questions
Why does the keypad not accept the access code?
If you enter the access code too fast on the keypad, the unlock function may not work. Slowly re-enter the access code.
Why does the keypad not function?
The keypad goes into an anti-scan mode if you enter a wrong code seven times. The anti-scan mode disables the keypad for one minute and the red light flashes.
Keyless Entry Keypad Personal Access Codes
Programming a Personal Entry Code
Enter the factory-set five-digit code.
Press 1·2 on the keypad within five
seconds.
Enter your personal five-digit code...
Easy Entry and Exit
How Does Easy Entry and Exit Work
Easy entry and exit moves the driver seat
rearward up to 2 in (5 cm) and the steering
column up when you switch the ignition off...
Other information:
Lincoln Nautilus 2018-2025 Service Manual: Washer Hose Repair. General Procedures
Repair NOTE: This procedure may be carried out on rubber hoses only. If a plastic washer hose is damaged, a new washer hose must be installed. Locate and verify the damaged washer hose. Cut the hose cleanly and remove the damaged portion of the washer hose...
Lincoln Nautilus 2018-2025 Owners Manual: Clearing the Garage Door Opener. Reprogramming the Garage Door Opener. Garage Door Opener Radio Frequencies
Clearing the Garage Door Opener Press and hold the outer two function buttons simultaneously for approximately 10 seconds until the indicator light above the buttons flashes rapidly. When the indicator light flashes, release the buttons. Note: You cannot erase individual buttons...
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Auto-Start-Stop
- Switching the Lane Keeping System On and Off. Switching the Lane Keeping System Mode
- Programming the Garage Door Opener to Your Garage Door Opener Motor
- New on site
- Most important about car
Traction Control
How Does Traction Control Work
If your vehicle begins to slide, the system applies the brakes to individual wheels and, when needed, reduces power at the same time. If the wheels spin when accelerating on slippery or loose surfaces, the system reduces power in order to increase traction.
Switching Traction Control On and Off
WARNING: The stability and traction control light illuminates steadily if the system detects a failure. Make sure you did not manually disable the traction control system using the information display controls or the switch. If the stability control and traction control light is still illuminating steadily, have the system serviced by an authorized dealer immediately. Operating your vehicle with the traction co
