Lincoln Nautilus: Wipers and Washers / Windshield Wiper Motor. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the wiper linkage assembly.
Refer to: Wiper Linkage Assembly (501-16 Wipers and Washers, Removal and Installation).
-
NOTICE:
Be careful not to damage the link seals during
removal. Failure to follow this instruction may result in poor
windshield wiper performance.
Detach the windshield wiper link from the windshield wiper motor crank.
-
Detach the link.
-
Position the link aside.
-
Remove the wiper motor bolts.
Torque:
115 lb.in (13 Nm)
-
Remove the windshield wiper motor.
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Fluid Suction Gun
Fluid Container
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Special Tool(s) /
General Equipment
Two Leg Puller
Removal
Remove windshield wiper pivot arm nut covers.
Remove windshield wiper pivot arm nuts...
Other information:
DTC Chart: DDM
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
DTC
Description
Action
B1163:11
Left Mirror Heater Output: Circuit Short To Ground
GO to Pinpoint Test D
..
Removal
NOTE:
This step is only necessary if the IPMB is being replaced.
NOTE:
This procedure can be used for all locations of the component.
Using a diagnostic scan tool, begin the PMI process for the IPMB following the on-screen instructions.
Position the front driver seat to access the IPMB .
Remove the retainers and the IPMB cove..