Lincoln Nautilus Manuals

Lincoln Nautilus: Handles, Locks, Latches and Entry Systems / Door Latch Lubrication. General Procedures

Special Tool(s) / General Equipment

Flat-Bladed Screwdriver

Materials

Name Specification
Motorcraft® Multi-Purpose Grease Spray
XL-5-A
ESB-M1C93-B
 

Activation

NOTE: Typical left front door shown, others similar.

  1. Open the door.
  1. Using a flat blade screwdriver, fully close the latch (2 clicks).
    Use the General Equipment: Flat-Bladed Screwdriver
  1. NOTICE: Do not over-lubricate the latch. Using excessive grease may damage the internal lock motor.

    Spray the multi-purpose grease into the opening on the door latch for approximately 5 seconds.
    Material: Motorcraft® Multi-Purpose Grease Spray / XL-5-A (ESB-M1C93-B)
  1. NOTE: Some exterior door handles are operated mechanically while other exterior door handles are operated electronically.

    Open the latch using the exterior door handle.
  1. Open and close the door several times to circulate the lubricant inside the latch.
  1. Open the door.
  1. Wipe off any excess grease.

    Locks, Latches and Entry Systems. Diagnosis and Testing

    DTC Charts Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...

    Liftgate Latch Manual Release. General Procedures

    Special Tool(s) / General Equipment Flat-Bladed Screwdriver Activation All vehicles NOTE: LH side shown, RH side similar. On both sides...

    Other information:

    Lincoln Nautilus 2018-2025 Service Manual: Specifications


      Lubricants, Fluids, Sealers and Adhesives Item Specifications Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid / PM-20 WSS-M6C65-A2   Torque Specifications Item Nm lb-ft lb-in Front caliper bleeder screw 17 - 150 Rear caliper b..

    Lincoln Nautilus 2018-2025 Service Manual: Wheel and Tire. Disassembly and Assembly


    Special Tool(s) / General Equipment Wooden Block DISASSEMBLY NOTICE: Failure to follow the instructions below may result in damage to the TPMS . NOTICE: The TPMS sensor is mounted to the valve stem. Removal of the valve stem requires dismounting the tire from the wheel and removal of the TPMS sensor. NOTE: Use only the Digital Tire Pressure Gauge any time tire pressures ..

    Categories

    Changing a Flat Tire

    WARNING: If the tire pressure monitor sensor becomes damaged it may not function.

    Note: The use of tire sealant may damage your tire pressure monitoring system and should only be used in roadside emergencies. If you must use a sealant, use the Tire Mobility Kit sealant. Replace the tire pressure monitoring system sensor and valve stem on the wheel by an authorized dealer after use of the sealant.

    Note: The tire pressure monitoring system indicator light will illuminate when the spare tire is in use. To restore the full function of the monitoring system, all road wheels equipped with tire pressure monitoring sensors must be mounted on the vehicle.

    If you get a flat tire while driving, do not apply the brake hea

    read more

    Copyright © 2025 www.linautilus.com