Lincoln Nautilus Manuals

Lincoln Nautilus: Parking Aid - Vehicles With: Rear Parking Aid / Elevation System Check. General Procedures

Check

  1. Turn the ignition ON, engine OFF.
  1. Set the parking brake.
  1. Place the gearshift in REVERSE (R) for rear parking aid sensors.
  1. Place the gearshift in DRIVE (D) for front parking aid sensors.
  1. Using a diagnostic scan tool, monitor the parking aid sensor distance Parameter Identifications (PIDs) to verify no objects are detected.
  1. If the audible warning is heard or if the Parameter Identifications (PIDs) indicate an object is detected, check to make sure the bumper is correctly installed and is not tilted downward so the sensor is pointing at the ground. Refer to Diagnosis and Testing.

    Azimuth System Check. General Procedures

    Check NOTE: The object used in this system check can be fabricated using a 9 cm diameter (3 in I.D.) pipe, 100 cm (39 in) in length (available as Polyvinyl Chloride (PVC) pipe, or similar from a hardware or plumbing supply...

    Front Parking Aid Sensor. Removal and Installation

    Removal NOTE: This procedure can be used for all locations of the component. Remove the front bumper cover. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation)...

    Other information:

    Lincoln Nautilus 2018-2026 Service Manual: Tire Pressure Monitoring System (TPMS). Diagnosis and Testing


    DTC Charts Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).   RTM DTC Chart DTC Description Action U0146:00 Lost Communication with Gateway "A": No Sub Type Information &nbs..

    Lincoln Nautilus 2018-2026 Service Manual: Connecting Rod Bearing Journal Clearance. General Procedures


    Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: The crankshaft connecting rod journals must be within specifications to check the connecting rod bearing journal clearance. Remove the connecting rod bearing cap and connecting rod bearing. Position a piece of Plastigage across the bearing surface. NOTE: D..

    Categories

    Clearing the Garage Door Opener. Reprogramming the Garage Door Opener. Garage Door Opener Radio Frequencies

    Clearing the Garage Door Opener

    Lincoln Nautilus. Clearing the Garage Door Opener. Reprogramming the Garage Door Opener. Garage Door Opener Radio Frequencies

    Press and hold the outer two function buttons simultaneously for approximately 10 seconds until the indicator light above the buttons flashes rapidly. When the indicator light flashes, release the buttons.

    read more

    Copyright © 2026 www.linautilus.com