Lincoln Nautilus: Seatbelt Systems / Seatbelt Cleaning. General Procedures
Cleaning
WARNING:
Do not bleach or re-dye the seatbelt webbing, as the webbing
may weaken. Failure to follow this instruction may increase the risk of
serious personal injury or death in a crash.
-
Refer to the owner's literature for information on
seatbelt care and the recommended cleaning solution to use. Follow the
manufacturer's instructions provided with the cleaning solution.
Repair
NOTE:
If the seatbelt webbing does not extract from the seatbelt
retractor from the stowed position, this may be due to a normal
condition which happens when the seatbelt retracts at a high rate of
speed...
Inspection
WARNING:
All seatbelt components must be inspected and corrected as
part of any collision repair. Inspect all seatbelt components as
prescribed by Seatbelt Procedure After a Collision found in Section
501-20A General Procedures of this manual...
Other information:
Launching or Retrieving a Boat or Personal Watercraft
When backing down a ramp during boat
launching or retrieval:
Do not allow the static water level to rise
above the bottom edge of the rear
bumper.
Do not allow waves to break higher than
6 in (15 cm) above the bottom edge of
the rear bumper...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the LH rear seat backrest cover.
Refer to: Rear Seat Backrest Cover (501-10B Rear Seats, Removal and Installation).
Remove the backrest foam...