Lincoln Nautilus: Interior Trim and Ornamentation / D-Pillar Trim Panel. Removal and Installation
Special Tool(s) / General Equipment
| Interior Trim Remover |
Removal
NOTE: RH side shown, LH side similar.
-
Remove the loadspace trim panel.
Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation) .
-
Release the pin-type retainers.
Use the General Equipment: Interior Trim Remover
.jpg) |
-
NOTICE: The trim panel must be positioned downward to allow the upper clip to release correctly. Failure to follow this direction may cause damage to the trim panel.
Slide the D-pillar trim panel down, aligning the clip to the slot in the sheet metal.
 |
-
Remove the D-pillar trim panel.
 |
Installation
-
To install, reverse the removal procedure.
C-Pillar Trim Panel. Removal and Installation
Removal
NOTE:
RH side shown, LH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the loadspace trim panel...
Front Door Trim Panel. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Release the clips and remove the door trim panel bolt cover...
Other information:
Lincoln Nautilus 2018-2025 Service Manual: Intrusion Sensor. Removal and Installation
Removal Remove the overhead console. Refer to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation). Release the tabs and position aside the sensors. Position aside the wire harness...
Lincoln Nautilus 2018-2025 Owners Manual: Interior Mirror
Interior Mirror Precautions WARNING: Do not adjust the mirrors when your vehicle is moving. This could result in the loss of control of your vehicle, serious personal injury or death. Note: Do not clean the mirror housing or glass with harsh abrasives, fuel or other petroleum-based cleaning products...
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Opening and Closing the Hood
- Locating the Pre-Collision Assist Sensors
- Opening the Liftgate
- New on site
- Most important about car
Changing a Flat Tire
WARNING: If the tire pressure monitor sensor becomes damaged it may not function.
Note: The use of tire sealant may damage your tire pressure monitoring system and should only be used in roadside emergencies. If you must use a sealant, use the Tire Mobility Kit sealant. Replace the tire pressure monitoring system sensor and valve stem on the wheel by an authorized dealer after use of the sealant.
Note: The tire pressure monitoring system indicator light will illuminate when the spare tire is in use. To restore the full function of the monitoring system, all road wheels equipped with tire pressure monitoring sensors must be mounted on the vehicle.
If you get a flat tire while driving, do not apply the brake hea
