Lincoln Nautilus: Glass, Frames and Mechanisms / Front Door Glass Run and Bracket. Removal and Installation
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
The front door glass run and bracket is serviced with the door latch assembly only.
-
Remove the front door latch.
Refer to: Front Door Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
Installation
-
To install, reverse the removal procedure.
-
Carry out the power door window initialization.
Refer to: Power Door Window Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).
Removal
Remove the driver door window control switch.
Remove the driver door window control switch and the bezel assembly.
Disconnect the driver door window control switch electrical connector...
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the front door window regulator and motor...
Other information:
Removal
Remove the headlamp assembly.
Refer to: Headlamp Assembly (417-01 Exterior Lighting, Removal and Installation).
Remove the screws and position the ballast.
Disconnect the electrical connectors and remove the ballast...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary when installing a new component.
NOTE:
The PMI process must begin with the current SCCM installed. If the
current SCCM does not respond to the diagnostic scan tool, the tool may
prompt for As-Built Data as part of the repair...