Lincoln Nautilus: Body Closures / Front Door. Removal and Installation
Special Tool(s) /
General Equipment
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
-
Open the door.
-
Remove the check arm bolt.
Torque:
18 lb.ft (25 Nm)
-
Disconnect the front door electrical connector.
-
Remove the door hinge pivot bolts.
Use the General Equipment: Door Lift
Torque:
22 lb.ft (30 Nm)
-
Remove the door.
Use the General Equipment: Door Lift
Installation
-
To install, reverse the removal procedure.
-
NOTE:
This step is only necessary when installing a new component.
Check the door-to-body alignment. Align the door as necessary.
Refer to: Front Door Alignment (501-03 Body Closures, General Procedures).
Inspection
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Inspect the rear door-to-body dimensions...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Open the door...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Driver seat control switch shown, passenger seat control switch similar.
Remove the side shield screws.
Remove the side shield...
Inspection
WARNING:
If a vehicle has been in a crash, inspect the Restraints
Control Module (RCM) and impact sensor mounting areas for any damage or
deformation. Also inspect the related components for any cracks, damage,
or loose fasteners...