Lincoln Nautilus: Exterior Lighting / Headlamp Bulb. Removal and Installation
Removal
-
Remove the headlamp assembly.
Refer to: Headlamp Assembly (417-01 Exterior Lighting, Removal and Installation).
-
Remove the screws and position the ballast.
 |
-
Disconnect the electrical connectors and remove the ballast.
.jpg) |
-
Disconnect the headlamp bulb electrical connector.
 |
-
Remove the headlamp bulb.
-
Squeeze the tabs together lift up and release the spring retainers.
-
Remove the headlamp bulb.
-
Squeeze the tabs together lift up and release the spring retainers.
 |
Installation
-
To install, reverse the removal procedure.
Headlamp Assembly. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers)
...
Headlamp Control Module (HCM). Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary if the HCM is being replaced...
Other information:
Lincoln Nautilus 2018-2026 Service Manual: Rear Suspension Bracket Reinforcement. Removal and Installation
Special Tool(s) / General Equipment 8 mm Drill Bit MIG/MAG Welding Equipment Spot Weld Drill Bit Locking Pliers Removal NOTE: LH side shown, RH side similar. NOTE: Factory welds may be substituted with resistance or metal inert gas (MIG) plug welds...
Lincoln Nautilus 2018-2026 Service Manual: Audio Front Control Module (ACM). Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation...
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Replacing the Rear Wiper Blades
- Fuel Quality
- Folding the Exterior Mirrors - Vehicles With: Manual Folding Mirrors. Folding the Exterior Mirrors - Vehicles With: Power Folding Mirrors
- New on site
- Most important about car
Traction Control
How Does Traction Control Work
If your vehicle begins to slide, the system applies the brakes to individual wheels and, when needed, reduces power at the same time. If the wheels spin when accelerating on slippery or loose surfaces, the system reduces power in order to increase traction.
Switching Traction Control On and Off
WARNING: The stability and traction control light illuminates steadily if the system detects a failure. Make sure you did not manually disable the traction control system using the information display controls or the switch. If the stability control and traction control light is still illuminating steadily, have the system serviced by an authorized dealer immediately. Operating your vehicle with the traction co
