Lincoln Nautilus Manuals

Lincoln Nautilus: Body Closures / Power Liftgate Initialization. General Procedures

Lincoln Nautilus 2018-2026 Service Manual / Body and Paint / Body and Paint / Body Closures / Power Liftgate Initialization. General Procedures

Initialization

  1. Disconnect the battery or remove the RGTM fuse(s).
    Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
  1. NOTE: Remove the battery power from the RGTM for 20 seconds before entering initialization mode.

    Wait 20 seconds and reconnect the battery or reinstall the RGTM fuse(s).
    Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
  1. If the liftgate is not already in the fully closed position, manually close and fully latch the power liftgate.
  1. Using a diagnostic scan tool, cleat all fault codes for the RGTM .
  1. NOTE: If equipped, make sure the power liftgate system is turned ON in the message center before performing this step.

    NOTE: If the power liftgate does not open during this step, refer to the Symptom Chart to diagnose the inoperative power liftgate.

    Power open the liftgate by using a programmed RKE transmitter or the front control switch.
  1. Once the liftgate is fully open, power close the liftgate by using a programmed RKE transmitter or the front power liftgate control switch.
  1. Carry-out the RGTM self-test.

    Liftgate Alignment. General Procedures

    Inspection NOTE: Removal steps in this procedure may contain installation details. Check liftgate-to-body dimensions. Refer to: Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation)...

    Rear Door Alignment. General Procedures

    Inspection NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. Inspect the rear door-to-body dimensions...

    Other information:

    Lincoln Nautilus 2018-2026 Service Manual: Airbag and Seatbelt Pretensioner Supplemental Restraint System (SRS) - Component Location. Description and Operation


    Item Description 1 Driver and passenger C-pillar side impact sensors 2 Driver front door side impact sensor 3 Clockspring 4 PAD indicator 5 RCM 6 OCSM (includes OCS sensor and gel-filled bladder) 7 Passenger front door side impact sensor 8 Seat position sensors 9 LH and RH front impact severity sensors ..

    Lincoln Nautilus 2018-2026 Service Manual: Sealer, Underbody Protection Material and Adhesives. Description and Operation


    Adhesives NOTE: The following illustrations are examples of structural adhesive application and are not all inclusive. The correct adhesive bonding is essential to repairing the vehicle correctly. Adhesives are used in many areas of the body structure in place of welding. In addition to providing a structural bond between component, adhesives can also help prevent wind noise, water leak..

    Categories

    Traction Control

    How Does Traction Control Work

    If your vehicle begins to slide, the system applies the brakes to individual wheels and, when needed, reduces power at the same time. If the wheels spin when accelerating on slippery or loose surfaces, the system reduces power in order to increase traction.

    Switching Traction Control On and Off

    WARNING: The stability and traction control light illuminates steadily if the system detects a failure. Make sure you did not manually disable the traction control system using the information display controls or the switch. If the stability control and traction control light is still illuminating steadily, have the system serviced by an authorized dealer immediately. Operating your vehicle with the traction co

    read more

    Copyright © 2026 www.linautilus.com