Lincoln Nautilus: Steering Wheel and Column Electrical Components / Steering Column Control Switch. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the steering column shrouds.
Refer to: Steering Column Shrouds (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Turn the steering wheel 90 degrees left.
-
Remove the screws.
-
Squeeze the tabs and remove the steering column control switch.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary when installing a new component...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the steering column shrouds.
Refer to: Steering Column Shrouds (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Other information:
System Operation
System Diagram
Item
Description
1
Turn signal/hazard on tick-tock tone
2
IPC
3
ABS module
4
IPMA
5
BCM
6
Driver door ajar switch
7
Driver seatbelt buckle switch
8
RCM
9
PCM
10
GWM
11
ACM
12
Rear speakers
13
Front speakers
14
Audio DSP module..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Detach the windshield washer hose coupling.
Remove the clip and position the cowl panel up.
Route the washer hose through the cowl panel.
NOTE:
LH side shown, RH side similar.
Index-mark the hood hinge..