Lincoln Nautilus: Wipers and Washers / Washer Hose Repair. General Procedures
Repair
NOTE:
This procedure may be carried out on rubber hoses only. If a
plastic washer hose is damaged, a new washer hose must be installed.
-
Locate and verify the damaged washer hose.
-
Cut the hose cleanly and remove the damaged portion of the washer hose.
Dimension:
0.5000
in (
12.7
mm)
-
Install a windshield washer hose adapter between the cut ends of the hose.
-
NOTE:
In difficult cases, clamping may be required.
If necessary, install a segment of 6.4 mm (0.25 in) ID
black rubber hose over the ends of the washer hose and clamp both ends
of the rubber hose using spring clamps.
Disconnect
WARNING:
Before beginning any service procedure in this
section, refer to Safety Warnings in section 100-00 General Information...
Removal
Remove the front parking aid camera.
Refer to: Front Parking Aid Camera (413-13B)
.
Disconnect the hose and remove the front parking aid camera washer jet...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the GSM .
Refer to: Gear Shift Module (GSM) (307-05A Automatic Transmission
External Controls - 8-Speed Automatic Transmission – 8F57, Removal and
Installation)...
When you use them properly, the seat, head
restraint, seatbelt and airbags will provide
optimum protection in the event of a crash.
We recommend that you follow these
guidelines:
Sit in an upright position with the base of
your spine as far back as possible...