Lincoln Nautilus: Suspension / Wheels and Tires
- Specifications
- Safety Precautions - Overview. Description and Operation
- Wheels and Tires. Diagnosis and Testing
- Wheel to Hub Runout Minimization. General Procedures
- Wheel to Tire Runout Minimization. General Procedures
- Wheel and Tire. Removal and Installation
- Wheel and Tire. Disassembly and Assembly
Wheel Studs. Removal and Installation
Special Tool(s) /
General Equipment
Hydraulic Press
Removal
Remove the wheel bearing and wheel hub.
Refer to: Wheel Bearing and Wheel Hub - AWD (204-02 Rear Suspension, Removal and Installation)...
Specifications
Material
Item
Specification
Fill Capacity
Motorcraft® High Temperature Nickel Anti-Seize Lubricant
XL-2
-
Motorcraft® Wheel and Tire Cleaner
ZC-37-A
-
General Specifications
Item
Specification
Tire Inflation
Tires
See Safety Certi..
Other information:
Lincoln Nautilus 2018-2025 Service Manual: Roof Opening Panel Fixed Glass. Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. Place the roof opening panel shield to the fully OPEN position. NOTE: RH side shown, LH side similar. On both sides. Detach part of the roof opening panel seal from the roof opening panel frame as necessary. NOTE: RH side shown, LH ..
Lincoln Nautilus 2018-2025 Service Manual: Oil Pressure Test - Gasoline. General Procedures
Oil Pressure Test 2.7L EcoBoost & 3.3L Duratec & 5.0L Ti-VCT NOTE: It is necessary to disconnect the battery to avoid setting any DTCs that could cause the PCM to command the oil pressure to other than what should be observed from a correctly operating system during the oil pressure test. Disconnect the battery ground cable. For additional information, refer to: Battery Disc..
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Normal Scheduled Maintenance
- Engine Oil Capacity and Specification - 2.0L
- Changing the 12V Battery
- New on site
- Most important about car
Traction Control
How Does Traction Control Work
If your vehicle begins to slide, the system applies the brakes to individual wheels and, when needed, reduces power at the same time. If the wheels spin when accelerating on slippery or loose surfaces, the system reduces power in order to increase traction.
Switching Traction Control On and Off
WARNING: The stability and traction control light illuminates steadily if the system detects a failure. Make sure you did not manually disable the traction control system using the information display controls or the switch. If the stability control and traction control light is still illuminating steadily, have the system serviced by an authorized dealer immediately. Operating your vehicle with the traction co
