Lincoln Nautilus: Handles, Locks, Latches and Entry Systems / Liftgate Release Switch. Removal and Installation
Removal
-
Remove the reversing lamp.
Refer to: Reversing Lamp (417-01 Exterior Lighting, Removal and Installation).
-
Disconnect the liftgate release switch electrical connector.
 |
-
Remove the liftgate release switch.
-
Press the retaining tabs on the liftgate release switch.
-
Remove the liftgate release switch.
-
Press the retaining tabs on the liftgate release switch.
 |
Installation
-
To install, reverse the removal procedure.
Liftgate Latch. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Rear Door Latch. Removal and Installation
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the exterior rear door handle...
Other information:
Lincoln Nautilus 2018-2026 Service Manual: Jacking and Lifting - Overview. Description and Operation
Jacking and Lifting Points NOTE: LH side shown, RH side similar. Only the specified jacking points may be used for jacking and supporting the vehicle. WARNING: Position the hoist lift arms as shown in the illustration. Incorrect positioning could result in vehicle slipping or falling from the hoist...
Lincoln Nautilus 2018-2026 Service Manual: Tire Pressure Monitoring System (TPMS) - Overview. Description and Operation
Overview The BCM uses tire pressure sensors to monitor tire pressure. The sensors use radio signals to transmit the tire pressure to the RTM . The RTM sends the information to the BCM over the Medium Speed Controller Area Network (MS-CAN) and K-Line...
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Programming the Garage Door Opener to Your Garage Door Opener Motor
- Replacing the Rear Wiper Blades
- Auto Hold
- New on site
- Most important about car
Auto-Start-Stop
What Is Auto-Start-Stop
The system is designed to help reduce fuel consumption and CO2 emissions by stopping the engine when it is idling, for example at traffic lights.
Auto-Start-Stop Precautions
WARNING: Apply the parking brake, shift into park (P), switch the ignition off and remove the key before you leave your vehicle. Failure to follow this instruction could result in personal injury or death.
WARNING: Apply the parking brake, shift into park (P), switch the ignition off and remove the key before you open the hood or have any service or repair work completed. If you do not switch the ignition off, the engine could restart at any time. Failure to follow this instruction could result in personal injury or d
