Other information:
Inspection
NOTE:
Procedure 1 — Ambient Temperature below 21 °C (70 °F).
NOTE:
Proper A/C system diagnosis on a vehicle’s
compressor is dependent on correct refrigerant system charge and tested
in ambient temperatures above 21°C (70°F). Perform the following steps
to achieve normal operating pressures.
Drive the vehicle or run the engine until it reaches normal operati..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The ABS module and HCU are released individually. A new ABS module does not come equipped with an HCU .
NOTE:
The PMI process must begin with the current ABS module installed. If
the current ABS module does not respond to the diagnostic scan tool, the
tool may prompt for As-Built Data as part..